Outdoor Lighting Fixtures

Flexible Waterproof Lighting Strip LED Ribbon 5 Meter or 16.4 Ft 12v PINK for All your Decorations Solder connection should only be performed on designated solder pads (marked " +/-"). During soldering, don't exceed the maximum soldering time of 10 seconds and the maximum soldering temperature of 260 celsius degrees. - The smallest unit (3 LEDs) can be removed by cutting with scissors between the designated solder pads. - The mounting of the strip is facilitated by means of the double-sided 3M adhesive tape on the back-surface of the strip. Care must be taken to provide a clean and dry mounting surface, free of oils or silicone coatings as well as dirt. The mounting substrate must have sufficient structural integrity. Take care to completely remove the adhesive backing. Once the strip is appropriately positioned, press firmly. (For further application information refer to application techniques of 3M adhesive transfer tapes). - The minimum bending radius is 2 cm. The strip may be bent over a smaller radius of the circuit board containing no electronic components and such bends should be made once and fixed in position to avoid cyclic fatigue. Strip lighting can be used for: Cove lighting, Architectural lights for canopy, corridor, window and archways. Back lighting or edge lighting for signage, DIY lighting for indoor use. Path or contour marking. Decorative lighting for festivals, events, shows, exhibitions and store showcases.

Product Features

• Waterproof with 3M two sided self adhesive tape
• Input Voltage:12VDC (Power Adapter Included)
• Bright, flexible LED strip lighting creates stunning effects.
• Just peel off the wax paper and stick it to any clean, dry substrate
• Great for: festivals, events, shows, parties, table decorations, stairs decorations, store showcases etc.